L293D Motor Control Shield for Arduino

(1 customer review)

৳ 225

  • 2 interface for 5V Servo connected to the Arduino’s high-resolution dedicated timer
  • Can drive 4 DC motors or 2 stepper motors or 2 Servo.
  • Up to 4 bi-directional DC motors with individual 8-bit speed selection.
  • Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
  • 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC.
  • Pull down resistors keep motors disabled during power-up.
  • 2 external terminal power interface, for seperate logic/motor supplies.
  • Tested compatible for Arduino Mega, Diecimila & Duemilanove.
  • Reset button.
  • Size:70*55mm

In stock

SKU: Box064 Categories: , , Tags: ,

L293D Motor Control Shield for Arduino

L293d motor driver shield for Arduino is a monolithic integrated that has a feature to adopt high voltage, high current at four channel motor driver designed to accept load such as relays solenoids, DC Motors and Stepper Motors and switching power transistor. To simplify to use as two bridges on each pair of channels and equipped with an enable input. A separate supply input is provided for the logic, allowing operation at a lower voltage and internal clamp diodes are included.  you can get special discount. Data Sheet of L293D motor control shield 4-Channel Stepper Motor Driver Board

The device is suitable for use in switching applications at frequencies up to 5kHz. The L293D is assembled in a 16 lead plastic package which has 4 center pins connected together and used for heat sinking. The L293D is assembled in a 20 lead surface mount which has 8 center pins connected together and used for heat shrinking.

To increase the maximum current, the L293D allows extra chips with “piggyback”. Piggyback is soldering one or two or three extra L293D drivers on top of the L293D drivers on the board to increase the maximum current. The L293D allows parallel operation. l293d motor driver shield for Arduino in bangladesh.

The Motor Shield is able to drive 2 servo motors, and has 8 half-bridge outputs for 2 stepper motors or 4 full H-bridge motor outputs or 8 half-bridge drivers, or a combination.

The servo motors use the +5V of the Arduino board. The voltage regulator on the Arduino board could get hot. To avoid this, the newer Motor Shields have connection points for a separate +5V for the servo motors.

Related Video : How to use L293D Motor Driver Shield with Arduino

For more Arduino boards, click here


Keep an eye on our website to avail the –

L293D Motor Control Shield for Arduino best price in BD (Bangladesh)

1 review for L293D Motor Control Shield for Arduino

  1. 5 out of 5

    no problem. thanks

Add a review