5V Relay Module

৳ 90৳ 140

রিলে দিয়ে কাজ করার জন্য কন্ট্রোল সার্কিট বানানোর ঝামেলা থাকছে না এই মডিউলে

  • Working voltage: 5V DC
  • Operating voltage: 5V DC
  • Compatible interfaces: 2.54 3-pin interface and 4-pin Grove interface(1)
  • Has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
  • Relay control interface by single-chip IO
  • Low-level suction close, high-level release
  • Easy to use, simple 3-line structure
  • Option of Single or dual Channel
SKU: N/A Categories: , ,

5V Relay Module

Single or Two Channel 5V Relay Module is a relay interface board that can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM, and so on. It uses a low-level triggered control signal (3.3 – 5V DC) to control the relay.

The electro-mechanical component known as a relay serves as a switch in some situations. In order to open or close contact switches, DC is used to energize the relay coil. A coil and two contacts, such as ordinarily open (NO) and usually closed (NC), are often found in a single-channel 5V relay module (NC). A 5v relay is an automatic switch that is commonly used in an automatic control circuit to control a high-current using a low-current signal. The input voltage of the 5V Relay Module signal ranges from 0 to 5V.

Specification

  • Working voltage: 5V DC
  • Operating voltage: 5V DC
  • Compatible interfaces: 2.54 3-pin interface and 4-pin Grove interface(1)
  • Has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
  • Relay control interface by single-chip IO
  • Low-level suction close, high-level release
  • Easy to use, simple 3-line structure
  • Option of Single or dual Channel

A blue plastic substance coating covers a 5V relay. The maximum working voltage and current for both AC and DC loads are also shown on the relay. This relay is known as a 5V relay because it uses 5V to operate.

On the top right side of the 5V relay module, a current-limiting resistor is used to connect the status LED. Therefore, by turning on the relay and coil through a signal pin, this LED displays the relay state. the DC voltages applied to a relay coil. The state of the power source connected via the single channel module is shown by the power LED. If we connect the aforementioned 5V source to the module’s Vcc and GND pins, the LED will be destroyed by excessive voltage.

 

5v-Single-Channel-Relay-Module-Pinout-robotechbd-bangladesh

Click Relay for more relay products

Additional Information

Relay Module

Single Channel, Dual Channel

0

TOP

X